|
|
Post by theblackspot on Sept 28, 2012 8:46:16 GMT -5
uberti cattleman. shoots left. have to hold front sight in right of rear sight. will epoxing a thin amount of metal to the front sight hold up to standard 44 special loads? should I pin it? thanks
|
|
turbo
.30 Stingray
Posts: 465
|
Post by turbo on Sept 28, 2012 8:57:11 GMT -5
I have the same problem with mine! shoots about 4-5 inches to the left.
|
|
|
|
Post by blacktailslayer on Sept 28, 2012 14:40:23 GMT -5
It appears that your barrel was over-rotated to properly regulate the sights.
Rotate your barrel to the right, to move your patterns left (as you look thru the sights). You do not have to rotate it very far to make a difference. Make reference marks somewhere so you know where you started and how far you have gone. Under the ERH is a popular place for these marks as they will not be visible after the work is done. If you make fine shallow marks with a scribe so they are narrow, I bet that you would only have to rotate the barrel the width of the mark or less. Top off the scribe marks with a cold blue or something similar to prevent corrosion.
Don D.
|
|
