|
|
Post by nobearsyet on Jun 19, 2009 12:24:49 GMT -5
Has anyone used one of the load generation programs? You know, the ones that will let you design a wildcat and then tell you where would be a good place to start and stop when working up a load? As some of you know I'm working on a pair of "480 Achilles" guns, one blackhawk and one levergun, problem though, to make it feed from the levergun I had to extend the case (read that as not trim it back as far, had to leave it .200 longer as a matter of fact) and now I have more capacity than I originally did, so I figure I ought ot use it, but I have no idea where to start.
|
|
|
|
Post by jforwel on Jun 23, 2009 15:07:03 GMT -5
I have never used it but I think the one you are talking about is "Load From a Disk". I believe that program allows you to plug in dimensions, weight, etc. and it gives appropriate powders and charges. www.loadammo.com/ |
|
|
|
Post by nobearsyet on Jun 24, 2009 0:33:50 GMT -5
I wasn't thinking about any specific program, just throwing a line out to see if anyone had one and might be persuaded a little to assist with starting loads for 480 Achilled long, as I had to add .200" to the case in order to make it feed through a levergun
|
|
|
|
Post by nobearsyet on Jun 26, 2009 11:19:12 GMT -5
Surprised being the power loving guys we are that nobody has one of these
|
|
Shakey
.327 Meteor
Central Arkansas
Posts: 548
|
Post by Shakey on Jun 26, 2009 13:32:03 GMT -5
You might try this link and see how it works for you. kwk.us/powley.html(I hope it's a link anyway. Not sure if I did it right) |
|
|
|
Post by nobearsyet on Jun 27, 2009 10:05:25 GMT -5
only works for rifle cartidges, but thanks for trying, also, the heeled bullet threw a wrench in the works
|
|
