Asm conversion 31 cal

[americanmutt]

singleactions.proboards.com/thread/27496/baby-dragoon-conversion

Hey all! New here best regards and Gods blessings

Above is the link to a thread that I am very much interested in doing to my asm baby dragoon. I see he turned the cylinder to 0.650. I am assuming that means how far down the nipple face was lowered? I have my gunsmith with a lathe and I was hoping to get advice on this measurement, and I am going to reAm the charge holes to accept 32 sw long. Any advice on where to measure and get better dimensions so I can Give them to my gunsmith?

Thanks!

[45MAN]

tinkerpearce USED TO BE A REGULAR ON THIS FORUM BUT HE HAS GONE "MIA" FOR A WHILE NOW, TOO BAD AS HE WAS ALWAYS DOING NEAT STUFF. MAYBE SOME FORUM MEMBERS HAVE CONTACT INFO FOR HIM.

[bigbrowndog]

I believe tinker is on YouTube but do not know his alias there. Others here should. He did come up with some neat projects.

Trapr

[bula]

I just saw a youtube of his yesterday ! It just popped up, I didn't search for. I'd say, find his posts here, think a clickable link on his posts that goes to his blog. Contact info maybe found there. 

[bula]

Try thru "tinkertalksguns.com". This gets you to a page. Link to his youtube, etc.. Gotta be a way !