45 Colt Chamber Reamer to Rent or Buy?

[x101airborne]

I am looking for a 45 Colt chamber finish reamer to rent or buy. 

I needed to take just a couple thousandths off the back of the cylinder to clear the recoil shield on my 1977 New Model Blackhawk. The process left just a small burr on one side of each of the cylinder chambers. Not wanting to just hawg at it with emery cloth or (gasp) a Dremel, I am looking for a good condition reamer. I literally only need it for the 6 holes of my cylinder and I am done. Before I buy a new one, I am checking to see if anyone has one they no longer need or want. Thanks for your time. 

[bigbore5]

If nothing else you can rent one from 4D. I've used some of their stuff and it was all in good condition when it arrived.

Have you tried just using a deburring tool? Or putting a slight chamfer on it?

[x101airborne]

No. I am worried my hay hooks for hands will off center or otherwise bugger up the cylinder. I'm sure Ronnie has one but I would have to drive up to Houston to use it and I dont know when that would be. Plus the chamber holes are so close to the ratchet boss there isn't any wiggle room for a slightly larger diameter tool to get in there without rubbing and being cocked off center. 

[sixguntech]

X101airborne,
I have one here somewhere, it is a Linebaugh spec (.480 case diameter and .453 throat). If that would work for you, I can scrounge it up over the weekend. I would need it back though, as I still have a project or two, I will need it for. Steve

[x101airborne]

Sixguntech, that would work. I would only need it for a couple days so that shouldn't be a problem. Thank you. PM incoming.

[rWt]

Send it to 2Dogs?