|
|
Post by statelineshootist on Oct 7, 2024 11:12:28 GMT -5
Long range front with #2 rear on a pre warning .357 in the first photo. Mirrored front with white outline rear on a flat top .44 Special in second photo. I know that Fermin’s sights are very well documented on this forum but I can’t stress enough how much more of an improvement over the factory ruger sights that his front and rear sights are.   |
|
|
|
Post by drycreek on Oct 7, 2024 14:44:10 GMT -5
They look good, now if I could only see well enough to use them.  |
|
|
|
Post by hgunhtr on Oct 7, 2024 19:38:39 GMT -5
just got done installing a 2 dogs front sight on a 4 5/8"stainless 44 special flattop. he recommended a .110 wide and a .400 tall. i had the sight bottomed out to zero at 25 yards. installed and went to the range. three shots to zero at 25 yards and then 3 in the middle in less than 3/4" cluster. i was vertical stringing with the factory sight due to a rounded top front sight. went to work off hand on an 8 inch plate at 25 yards shot about 50 rounds with just a few misses. has been a long time since i have shot irons, had to relearn to concentrate on the front sight not the target.
Thanks Fermin!!!
|
|
|
|
Post by leftysixgun on Oct 7, 2024 19:40:43 GMT -5
Can we see the mirror disk?
|
|
|
|
Post by bobwright on Oct 7, 2024 21:11:20 GMT -5
I don't have a Graza sight on any of my Rugers, nor have I ever seen one other than photographs. I have a Millett (no longer made) on a couple of Super Blackhawks and they are good for slow fire work. But my objection to them, and possibly to the Garza sight, is that they overhang the hammer too much to sjuit me, especially for defense work.  This rear sight from Gary Reeder (also no longer available) is better for fast and sure hammer cocking: .jpg?width=960&height=720&fit=bounds) Bob Wright |
|
|
|
Post by statelineshootist on Oct 8, 2024 11:44:30 GMT -5
Can we see the mirror disk? Attachments:
|
|
|
|
Post by boxhead on Oct 10, 2024 19:56:21 GMT -5
Fermin walked me through this front sight of his. He nailed it.   |
|
|
|
Post by statelineshootist on Oct 11, 2024 13:55:03 GMT -5
Fermin walked me through this front sight of his. He nailed it. very nice sights! |
|
markwell
.30 Stingray
Firearms resale value should be your children's problem
Posts: 354
|
Post by markwell on Nov 6, 2024 13:38:06 GMT -5
I've got Fermin's sights on 3 .32 H&R Single Six revolvers. They are a HUGE upgrade from the Ruger factory units May have to ask Fermin for a mirrored brass bead front for our 3.5" gun.
|
|
