EMF Pietta Great Western 2 cylinder not locking on one notch

[jhargett73]

I recently purchased a Pietta Great western 2. This is my first single action revolver, and I have only fired about 20 rounds through it. After this, I noticed that The cylinder would rotate slightly on the full cock position and a larger amount when the hammer was down on one notch. The rest appear to fit nicely. I would assume that the bolt is skipping back over the lead part of the notch, but I am not sure if this is to do with improper fitting of the bolt to the cylinder notch. What do you think this may be the cause of? Should i contact EMF or is that hassle not worth the time?

I have attached a link to a video of the problem below.

streamable.com/cfelvz

[Encore64]

It could be under timed on one ratchet tooth?

I'm sure those who know more will have better diagnosis...

[bigbore5]

Contact the factory. That one needs to go back.