KRal
.375 Atomic
Posts: 1,102
|
Post by KRal on Jun 5, 2024 11:47:04 GMT -5
I have a the above mentioned revolver with the sharp cylinder throats leads that cuts the lead rings with cast bullets. I’ve seen/read of a guy that corrects these, but can’t for the life of me remember who or where I seen this. Do any of you have contact info for this gentlemen? Thanks.
|
|
bamagreg
.327 Meteor
Woodstock, GA
Posts: 946
|
Post by bamagreg on Jun 5, 2024 12:37:27 GMT -5
He is dougguy on the Ruger forum. Here is the link to his facebook page: www.facebook.com/CylinderhoneYou also might check with Fermin (2dogs) on here. He likely can do that as well. |
|
|
|
Post by Lee Martin on Jun 5, 2024 12:37:40 GMT -5
I can't remember who that is, but I bet Ronnie Wells could fix them. And you're smart to want them honed. There's no better way to get dead nuts on dimensions and finish. -Lee www.singleactions.com"Chasing perfection five shots at a time" |
|
|
|
Post by leftysixgun on Jun 5, 2024 12:56:59 GMT -5
Doug guy is also on Castboolits site. He does great work! He honed several of my cylinders, he’s quick too.
|
|
KRal
.375 Atomic
Posts: 1,102
|
Post by KRal on Jun 5, 2024 13:30:12 GMT -5
He is dougguy on the Ruger forum. Here is the link to his facebook page: www.facebook.com/CylinderhoneYou also might check with Fermin (2dogs) on here. He likely can do that as well. That’s him, thanks! I’ve called Fermin on this issue and he said there was nothing he could do. |
|
KRal
.375 Atomic
Posts: 1,102
|
Post by KRal on Jun 5, 2024 13:31:40 GMT -5
I can't remember who that is, but I bet Ronnie Wells could fix them. And you're smart to want them honed. There's no better way to get dead nuts on dimensions and finish. -Lee www.singleactions.com"Chasing perfection five shots at a time" Lee, thanks. I may speak with Ronnie, as well. |
|
|
|
Post by foxtrapper on Jun 5, 2024 15:58:43 GMT -5
I can't remember who that is, but I bet Ronnie Wells could fix them. And you're smart to want them honed. There's no better way to get dead nuts on dimensions and finish. -Lee www.singleactions.com"Chasing perfection five shots at a time" Lee, thanks. I may speak with Ronnie, as well. Let us know what Ronnie has to say |
|
|
|
Post by bigbore5 on Jun 13, 2024 19:30:43 GMT -5
Cylinder hone recuts the lead to the throats from the silly sharp angle of the factory specs to a more middle angle. Eliminates those lead shaving donuts. Since he's using a Sunnen machine it's very concentric and mirror smooth.
|
|
