aciera
.375 Atomic
Posts: 2,211
Member is Online
|
Post by aciera on Jan 23, 2024 10:37:39 GMT -5
My Parker GHE I don’t worry about so much. Doug Turnbull went through is and all was good. But looking at a light 2” English 12 bore. And an 1800s 2 1/2”…….. I recently purchased an English gun. A Lancaster Damascus 2 1/2” 12 gauge. I intent to shoot sporting clays with it using my 3/4 oz load. It should be in the US in a few weeks. I’ve been load up some 2 1/2” loads. I originally used once fired RST hulls. I have access to a good source of them from a club that has a lot or wealth/vintage shooters!!!! lol. But they didn’t work that good. The Cheditte hulls are kind of cheap. So I’ve been cutting down Federal hulls to 2 1/2”. They work perfectly. I’ve been shooting them in an Ithaca NID for a few weeks. They crimp up nice after cutting down. Best part is I have an unlimited supply at my club guys just trash them. Only a few guys reload them.  That’s about where I’m going to be I hope. I’ll have a couple of traps in the back yard. But also 3 1/2 in brass for the 10 bore Neumann. |
|
woody
.375 Atomic
Posts: 1,116
|
Post by woody on Jan 23, 2024 13:32:53 GMT -5
That’s about where I’m going to be I hope. I’ll have a couple of traps in the back yard. But also 3 1/2 in brass for the 10 bore Neumann. Keep me posted on the 10 gauge project. |
|
aciera
.375 Atomic
Posts: 2,211
Member is Online
|
Post by aciera on Jan 23, 2024 16:57:14 GMT -5
That’s about where I’m going to be I hope. I’ll have a couple of traps in the back yard. But also 3 1/2 in brass for the 10 bore Neumann. Keep me posted on the 10 gauge project. I will. I have an Ithaca (pre NID) 2 5/8” I got a bunch of brass shotshells 10,12&20. A couple hundred total. Some are Bertrand so they have to be reworked. I am using 9.3x74R for 410 3”……..still looking for the right 3” 410. I have a 44(pre 410…..same size 2 1/2”) that is proper sized. For 28 I just have to bight the bullet |
|
