Need the name of a smith

squawberryman .458 Devastator You're never so tall as when you are down on your knees Posts: 7,186	Need the name of a smith Nov 4, 2023 8:11:25 GMT -5 via mobile Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by squawberryman on Nov 4, 2023 8:11:25 GMT -5 For an AR barrel threading with a decent turn time. LGS offers the service but no.
	The good Lord takes his fish fried If a LITTLE bit of butter makes it a LITTLE bit better.... WD40 will eat it's way out of a can, yet people spray it on their guns

squawberryman .458 Devastator You're never so tall as when you are down on your knees Posts: 7,186	Need the name of a smith Nov 4, 2023 10:30:57 GMT -5 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by squawberryman on Nov 4, 2023 10:30:57 GMT -5 Oops wrong category
	The good Lord takes his fish fried If a LITTLE bit of butter makes it a LITTLE bit better.... WD40 will eat it's way out of a can, yet people spray it on their guns

foxtrapper .401 Bobcat Posts: 2,925	Need the name of a smith Nov 4, 2023 10:39:28 GMT -5 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by foxtrapper on Nov 4, 2023 10:39:28 GMT -5 adcofirearms.com/products/gunsmithing/ In this commie state where I reside I use these fellas to remove threading on barrels. Lol always had good luck with them!

cas
.375 Atomic

Posts: 2,154

Need the name of a smith Nov 5, 2023 13:14:59 GMT -5

Quote

Post by cas on Nov 5, 2023 13:14:59 GMT -5

ADCO? Mmmm.....

I they did a pin and weld job for me where their drilled hole (and pin) didn't even make it all the way through the muzzle device, let alone into the barrel. Their response was basically "oh well, it happens".
So I swore them off and never hesitate to share the story.

Post by squawberryman on Nov 4, 2023 8:11:25 GMT -5

Post by squawberryman on Nov 4, 2023 10:30:57 GMT -5

Post by foxtrapper on Nov 4, 2023 10:39:28 GMT -5

Post by cas on Nov 5, 2023 13:14:59 GMT -5