|
|
Post by squawberryman on Jan 29, 2022 14:42:52 GMT -5
Has anyone loaded 327 specifically for long barrels? By long I mean 18 to 20 in any of the available lever guns. Thank you
|
|
|
|
Post by z1r on Jan 29, 2022 16:18:24 GMT -5
I don't have a .327 in a rifle but my experience with a .32 H&R in a 22" barrel showed that the slowest powders produced the greatest gains in the rifle barrel. Back in the day, that was H110.
|
|
|
|
Post by potatojudge on Jan 29, 2022 17:19:36 GMT -5
I’d take a Low Wall 327 in a heartbeat.
|
|
|
|
Post by 500fksjr on Jan 29, 2022 18:38:08 GMT -5
My 327 T/C 16.5 inch bbl pushes a 100 grn x tip at 1475 ( 13.6 gr lil gun)
|
|
|
|
Post by matt56 on Jan 29, 2022 19:50:42 GMT -5
I’ll have to double check my notes but I’m pretty sure I hit 1400 with a 100gr xtp out of a 4” SP-101 with Accurate #9.
|
|
denul
.240 Incinerator
Posts: 7 
|
Post by denul on Jan 30, 2022 11:21:23 GMT -5
I have the 20-in Henry lever action that I purchased in 2017, and posted a bit about it on the cast bullets website. Looking it over, it turns out that the hundred grain Hornady load was going about 1715 out of a 6-in revolver, with quite a lot of velocity variation, and then clocked at about 2,084 out of the 20-in henry. The rifle loads were so much more consistent. I think that my later experience using 296 and 300 MP for maximum velocity with heavier bullets also showed that the consistency was much greater when they were burned in a longer barrel.
|
|
|
|
Post by 45MAN on Jan 30, 2022 14:33:22 GMT -5
My 327 T/C 16.5 inch bbl pushes a 100 grn x tip at 1475 ( 13.6 gr lil gun) IS THAT MV A TYPO? SEEMS SLOW |
|
|
|
Post by 500fksjr on Jan 30, 2022 14:40:10 GMT -5
Do not think so we will re check it when the weather here warms up...
|
|
