WTS discount Ivory single action Grips

[lscg]

unfortunately while making this set my hand sipped and I took slightly too much material off the bottom front corner of the left panel. as you can see in the last two pics it's not off by much, just about the thickness of a business card. they actually were oversized on my 5 1/2" super Blackhawk.

the grips were fit to a XRN-3RED grip frame. they are thinner towards the butt than I normally make them (around .370) and have a really gorgeous grain to them.

normal price is $525. because of the small flaw i'll let these go for $375 shipped and insured. SOLD!!!!

cannot sell Ivory to you if you live in New York, New Jersey, California and Washington state.

[jdoc]

I'll take them. PM to follow.

[lscg]

these are Sold! thank you Sir!

[caryc]

In my ten or eleven years of making grips I couldn't count the number of grip frames I've had sent to me for fitting. The point is that I've seen those bottom corners with a very large radius on them and others where the corners almost came to a sharp point.

The frames vary a lot more than one might imagine. I'm thinking that those bottoms corners are finished by hand on a belt sander and it just depends on the guy doing it at the time. If I was making a pair of ivory grips for off the shelf sales, I think I would leave those bottom corners at almost sharp points and let the customer use a piece of sand paper and carefully fit them to his frame. Of course some may not agree with me.

Zane, maybe your customer will get lucky and he'll have a large radius on his corners. Below is an example of two customers frames.