|
Post by lscg on Nov 14, 2015 19:52:48 GMT -5
up for sale is a set of Curly Claro Walnut grips for the Ruger XRN-3RED grip frame (new model Blackhawk, single six, single Seven, and original Large frame Vaquero.) they were fit to a newer stainless Single Seven grip frame so they do not have the little notches cut into the backs of the grips to accommodate the little ramps/wedges that are on a lot of the older grip frames. if needed I can cut the notches.
price is $125 shipped and insured.
at the moment i'm out of grip screws and escutcheons but I have some on order and should get them next week.
|
|
Joe S.
.401 Bobcat
Posts: 2,517
|
Post by Joe S. on Nov 14, 2015 22:34:47 GMT -5
Those are beautiful!!
|
|
|
Post by nolongcolt on Nov 14, 2015 23:49:51 GMT -5
Would it be overly stupid to go out and buy a gun to fit some grips?!!??!?!
|
|
Joe S.
.401 Bobcat
Posts: 2,517
|
Post by Joe S. on Nov 15, 2015 8:30:56 GMT -5
Not when the grips look like that!
|
|
|
Post by lscg on Nov 15, 2015 14:59:53 GMT -5
|
|
|
Post by lscg on Nov 15, 2015 15:03:52 GMT -5
Would it be overly stupid to go out and buy a gun to fit some grips?!!??!?! not at all! in fact it gives you a good excuse to tell your wife " but Honey, I have to buy a new gun. if I don't it would be like wasting the money I spent on these grips"
|
|
|
Post by lscg on Nov 15, 2015 22:26:51 GMT -5
this set is now sold!
|
|