razor
.327 Meteor
Posts: 523
|
Post by razor on Jan 13, 2012 11:49:30 GMT -5
I put one of the wolf extra power hammer springs in my Bisley 45. I think it was the 25lb. The only trouble is the trigger pull went from 3lbs to about 4 or 4 1/2lbs. Can anything be done about this? I have done the poor man;s trigger job.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jan 13, 2012 15:50:07 GMT -5
Yeah, put the stock spring back in. Just kidding. Have you done the "poor mans" trigger job? It means to disconnect one of the trigger return springs legs off the pin under the grip panel.
|
|
|
|
Post by bigblue on Jan 13, 2012 18:27:58 GMT -5
|
|
|
|
Post by goodtime on Jan 13, 2012 19:37:16 GMT -5
Another vote here for the poor boy trigger job. I do it to all my Ruger single actions. It'll do the job. Here's a link: www.gunblast.com/Poorboy.htm |
|
Aggie01
.375 Atomic
max
Posts: 1,771
|
Post by Aggie01 on Jan 13, 2012 20:20:07 GMT -5
Polish the sear engagement surfaces with a fine stone.
All of my new model rugers have benefitted from this.
|
|
|
|
Post by jayhawker on Jan 13, 2012 21:18:30 GMT -5
Were you having ignition problems before change?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jan 13, 2012 21:34:16 GMT -5
I've used the Wolff reduced power [can't remember the poundage] trigger return spring but the trigger wouldn't always reset because it was so light.
|
|
|
|
Post by tek4260 on Jan 13, 2012 22:39:15 GMT -5
Polish the sear engagement surfaces with a fine stone. All of my new model rugers have benefitted from this. Sggie01 gave the best solution.... Also the factory sear angle is such that the hammer has to move back before releasing. Changing this helps tremendously. Also, they used to make a better trigger spring than the lighter ones available now.  The trigger reset problem with a light trigger return spring is caused by transfer bar pinch. File the second step of the hammer face to remove the pinch and the reset problem goes away. |
|
razor
.327 Meteor
Posts: 523
|
Post by razor on Jan 14, 2012 9:56:46 GMT -5
I have not had ignition problems. I did the poor man's trigger job.
|
|
|
|
Post by subsonic on Jan 14, 2012 10:33:48 GMT -5
I have the power custom hammer and trigger. I didn't notice much change in trigger pull when going from a stock to 26lb spring.
|
|
|
|
Post by subsonic on Jan 14, 2012 10:36:18 GMT -5
The power custom trigger spring will lower your pull. Some have bent the stock return spring legs to get a lower pull weight.
|
|
