tj3006
.375 Atomic
Posts: 1,965
|
Post by tj3006 on Apr 8, 2021 13:34:43 GMT -5
I got the rough country sight installed perfectly now. I went and bought a better set of pin punches. And I could not find a bench block locally , (does anybody have anything these day's ?) But i used a roll of masking tape , And the pin came out just fine. I called BCA about the little lock screw that was in the box. Jeremy explained that it is a longer replacement for the elevation set screw , should the one in the gun not provide enough room for adjustment. I dropped the Ruger spring in the whole to make adjustments a little easier , And now i am ready to try it out !...tj
|
|
rocdoc
.30 Stingray
Posts: 133
|
Post by rocdoc on Apr 10, 2021 0:26:24 GMT -5
Bench Block on eBay, I got the Wheeler Engineering version
|
|
|
Post by x101airborne on Apr 11, 2021 8:19:13 GMT -5
I made one from a poly cutting board I cut apart then glued in a stack. Ran a router over it a couple times and drilled a few holes. Done.
|
|
|
Post by richard on Apr 11, 2021 12:43:35 GMT -5
I made a bench block by drilling a 1/2” hole through a hockey puck. It cost me about $2.
|
|