|
Post by reconciler on Jan 2, 2021 17:57:21 GMT -5
The screw on the front of the trigger guard on my Colt SAA snapped off while trying to loosen it. I have done the following with no luck; -Drilled out the center of the screw and used an easy out bit...failed, snapped the bit -Red locktite a tight fitting allen wrench into the screw...failed locktite gave way
Does anyone have any tricks or ideas to help? I would sure appreciate any advice.
|
|
|
Post by tdbarton on Jan 2, 2021 19:41:47 GMT -5
Did it previously have loctite on it? If so, heat the screw with a soldering iron.
Rusted in place? Use penetrating oil and allow to soak for 48.
Then, if nothing else works, try to file/dremel a slot in the screw (sounds like this might not be possible) and remove with screwdriver.
Barring all this, the screw may have to be drilled out.
|
|
|
Post by williamiorg on Jan 9, 2021 11:19:29 GMT -5
Best penatrating oil I have worked with is Corrosion-X. Good penetration and a secret sauce that kills corrosion.
|
|
|
Post by bigbore5 on Jan 9, 2021 11:28:57 GMT -5
Knock-r-loose by CRC works great for a penetrating oil too
|
|