Bagby
.30 Stingray
Posts: 168
|
Post by Bagby on May 14, 2020 20:31:33 GMT -5
Well... I decided to fire up the lead pot, for the first time in a few years, and and play with the silver dragon. So I broke out the only .44 caliber molds I have. The Lyman 429215. And the Lyman 429303. I have only tried to cast bullets one other time. So It was a little bit of a learning curve getting the mold & the lead to cooperate. I had heard rumors that the 429303 was a pain to cast. However it didn’t seem to give me much trouble. Here are the results. 429215 And 429303And side by side for comparison. I am going to try them in the Turnbull NM Flattop .44 Special that I just picked up. What do y’all think? Any ideas for loads or manuals/magazine articles for load info with these bullets? Thanks, Jonathan.
|
|
|
Post by wheelguns on May 14, 2020 20:34:28 GMT -5
They look pretty good!
|
|
|
Post by boatswainsmate on May 14, 2020 20:39:56 GMT -5
Nice looking bullets!
|
|
|
Post by leftysixgun on May 14, 2020 22:24:19 GMT -5
Pretty neat, doesnt look quite natural to have a pointy 44 bullet....what does the 429-303 bullet weigh?
|
|
cheth
.240 Incinerator
Posts: 60
|
Post by cheth on May 14, 2020 22:32:45 GMT -5
That's sure a nice piece.
|
|
Ramar
.30 Stingray
Posts: 399
|
Post by Ramar on May 15, 2020 7:00:43 GMT -5
Good job casting, Jonathan. They're beautiful! (So is your Turnbull 44.) Thanks for posting pictures. How do you plan to lube those babies?
|
|
Bagby
.30 Stingray
Posts: 168
|
Post by Bagby on May 15, 2020 7:12:32 GMT -5
Leftysixgun. Just weighed a few. With Gas Check and no lube they are coming in around 215 Grains.
Ramar. Since I don’t have a lubrisizer yet I plan on pan lubing then sizing.
Thanks, Jonathan.
|
|
|
Post by sixshot on May 15, 2020 8:26:22 GMT -5
Good time to try powder coating. Just buy some powder from Smokes4320 & get a Lee sizer, probably .430" that fits right in your reloading press & you're all set. That Ray Thompson 429215 design is a dandy.
Dick
|
|
Bagby
.30 Stingray
Posts: 168
|
Post by Bagby on May 15, 2020 19:13:47 GMT -5
Sixshot. I just got finished doing some reading on powder coating. I believe I will be doing that instead of pan lubing. I went ahead and signed up on the cast boolits forum and sent smokes4320 a Pm.
Thanks, Jonathan.
|
|