Ramar
.30 Stingray
Posts: 399
|
Post by Ramar on May 9, 2020 9:36:43 GMT -5
If only it was an Old Model, I'd...
|
|
|
Post by cas on May 11, 2020 19:35:18 GMT -5
...the crown job is horrendous! That's just not true. There was no crown job.
|
|
|
Post by cas on May 11, 2020 19:39:27 GMT -5
Two things... I keeping wondering if the front sight is soldered on, or just like JB Weld. (which might be better, easier to knock it off when I put a scope on it! What's going on with the right side of the frame? Did they machine away the frame where the ejector rod goes in? If so, that makes the quality of the chop and "crown" work even more puzzling. Oh wait... this isn't the subject of the "bashing" thread is it?
|
|
|
Post by clintsfolly on May 11, 2020 21:08:11 GMT -5
Mama said if you can’t say something nice don’t say anything. So with that in mind “ Dropping it not going to hurt much! “
|
|
nicholst55
.375 Atomic
Retired, twice.
Posts: 1,039
|
Post by nicholst55 on May 12, 2020 4:47:51 GMT -5
My initial thought was that you could use the cylinder frame as a donor for a project gun, but the owner is way, way too proud of it. The serial number appears to be too high to permit opening up the cylinder window, and you would have to abrasive blast off the Cerakote and most likely end up with a matte finish.
|
|
bouddha
.30 Stingray
You can drown in hamster piss, but it might take a while.
Posts: 162
|
Post by bouddha on May 12, 2020 17:36:50 GMT -5
Izzat the new Wrangler Blackhawk?
|
|